Additional UI/Usability changes: - First Time Setup Wizard / Configuring Failure Check. Enabling Failure Check here will default Ethernet and WiFi as WAN checks to use a ping, and modems to Passive DNS. - Added IP WAN Subnet Filter checkbox to Modem Settings. - Added Enable AUX Antenna checkbox to Modem Settings. When disabled, the embedded modem’s AUX antenna is turned off. Defects fixed: - PMTU issue with IPSEC/VPN - System Stats SINR graph moved backwards - GPS change. GPS was being reported in degrees and decimal degrees. Now it is reported as degrees, minutes, and seconds. - USB Serial hardware flow control issue - AT&T Beam (Netgear AC340U) now works with i2gold SIMs Modems tested: - CradlePoint MC200LP2-EU / EE, Vodafone (UK), Tele2 (Sweden) / Supported on MBR1400, CBA750B Only - Netgear AC341U (“NETGEAR 341U USB Modem”) / Sprint (USA) - Pantech UML295VW (“Verizon 4G LTE USB Modem UML2954G LTE”) / Verizon (USA) Important: - Note 1: Before upgrading to new firmware, it is always a good idea to save the configuration file from your current version. This firmware version will remove a configuration for version 3.2 or lower and will not try to keep your settings. - Note 2: Revision 5.0.0 is a significant change from previous releases. Updating from prior versions to 5.0.0 through the router UI or ECM will keep all current settings. Factory resetting 5.0.0 and then re-applying a saved configuration from an earlier version may not reset all saved passwords correctly. Downgrading from 5.0.0 or later to an earlier version WILL force a factory reset on the router. Saving a 5.0.0 or later configuration and applying it to an earlier version will change any non-default passwords to an unknown string.
Скачать