* Fixed an issue where if you used a Harpertown 2.50GHz CPU you were unable to resume from a S3 wait state * Added Hotkey pressed will pop up a BIOS boot menu so that chose boot device * Fixed an issue where an nVidia Quadro Plex IV would show a ! next to one set of cards in the device manager * Updated CPU Micro Code * Added Hotkey pressed forces LAN PXE boot * Fixed an issue where disabling PATA or setting SATA to compatible when there is a SATA drive plugged to Port 1 or Port 3 BIOS will show error message "0200: Failure Fixed Disk 1" on POST screen * Set BIOS continuous reboot mode by item * Updated ESB2 LAN PXE Option ROM is set to [Enable] by default * Fixed an issue where DIMM size was displayed wrong in the DMI table * Set max L2 cache size to 12288KB * Fixed an issue where PCI-X slot 2 and 3 Option ROM disable function wouldn’t disable properly * Fixed an issue where if you would disable the WOL function from BIOS setup it wouldn’t also apply to a PCI32 LAN card * Updated to Intel MRC to v1.1 * Updated ESB2 AHCI Option ROM to v1.12E * Adjusted thermal control and set auto fan control enabled as default * Fixed and issue where dual VGA cards would show a yellow ! next to the 2nd card under Vista * Fixed an issue where the auto fan controls were not working properly * Fixed an issue where the Front and Rear FAN controls were not working properly * Fixed an issue where auto fan control would not works after S3 resume * Updated the Intel MRC code * Fixed an issue where S3 would fail if using RAID * Fixed an issue where IDE and USB CD-ROM would not function properly * Fixed an issue where booting from RAID with SATA CD-ROM would cause the system to hang during POST (d2H)
Скачать