CPU 1. Support for an Intel Core i7 series processor in the LGA 1366 package 2. L3 cache varies with CPU QPI 1. 4.8GT/s / 6.4GT/s Chipset 1. North Bridge: Intel X58 Express Chipset 2. South Bridge: Intel ICH10R Memory 1. 4 x 1.5V DDR3 DIMM sockets supporting up to 16 GB of system memory 2. Dual/3 channel memory architecture 3. Support for DDR3 2000+/1333/1066/800 MHz memory modules Audio 1. Realtek ALC888 codec 2. High Definition Audio 3. 2/4/5.1/7.1-channel 4. Support for S/PDIF In/Out 5. Support for CD In LAN 1. 1 x Realtek 8111D chips (10/100/1000 Mbit) Expansion Slots 1. 2 x PCI Express x16 slots, running at x16 (The PCI Express slots conform to PCI Express 2.0 standard.) 2. 1 x PCI Express x4 slot 3. 2 x PCI Express x1 slot 4. 2 x PCI slots Storage Interface South Bridge: 1. 6 x SATA 3Gb/s connectors (SATA2_0, SATA2_1, SATA2_2, SATA2_3, SATA2_4, SATA2_5) supporting up to 6 SATA 3Gb/s devices 2. Support for SATA RAID 0, RAID 1, RAID 5, and RAID 10 GIGABYTE SATA2 1. 1 x IDE connector supporting ATA-133/100/66/33 and up to 2 IDE devices 2. 2x SATA 3Gb/s connectors (GSATA2_0, GSATA2_1) supporting up to 2 SATA 3Gb/s devices 3. Support for SATA RAID 0, RAID 1 and JBOD iTE IT8720 chip: 1. 1 x floppy disk drive connector supporting up to 1 floppy disk drive IEEE 1394 1. T.I. TSB43AB23 chip 2. Up to 3 IEEE 1394a ports (1 on the back panel, 2 via the IEEE 1394a brackets connected to the internal IEEE 1394a headers) USB 1. Integrated in the South Bridge 2. Up to 12 USB 2.0/1.1 ports (8 on the back panel, 4 via the USB brackets connected to the internal USB headers) Internal I/O Connectors 1. 1 x 24-pin ATX main power connector 2. 1 x 8-pin ATX 12V power connector 3. 1 x floppy disk drive connector 4. 1 x IDE connector 5. 8 x SATA 3Gb/s connectors 6. 1 x CPU fan header 7. 3 x system fan headers 8. 1 x power fan header 9. 1 x North Bridge fan header 10. 1 x front panel header 11. 1 x front panel audio header 12. 1 x CD In connector 13. 1 x S/PDIF In header 14. 1 x S/PDIF Out header 15. 2 x USB 2.0/1.1 headers 16. 1 x IEEE 1394a headers 17. 1 x serial port header 18. 1 x power LED header 19. 1 x chassis intrusion header 20. 1 x clearing CMOS jumper Back Panel Connectors 1. 1 x PS/2 keyboard port 2. 1 x PS/2 mouse port 3. 1 x coaxial S/PDIF Out connector 4. 1 x optical S/PDIF Out connector 5. 2 x IEEE 1394a port 6. 8 x USB 2.0/1.1 ports 7. 1 x RJ-45 ports 8. 6 x audio jacks (Center/Subwoofer Speaker Out/Rear Speaker Out/Side Speaker Out/Line In/Line Out/Microphone) I/O Controller 1. iTE IT8720 chip H/W Monitoring 1. System voltage detection 2. CPU/System/North Bridge temperature detection 3. CPU/System/Power fan speed detection 4. CPU overheating warning 5. CPU/System/Power fan fail warning 6. CPU/System fan speed control BIOS 1. 2 x 8 Mbit flash 2. Use of licensed AWARD BIOS 3. Support for DualBIOS 4. PnP 1.0a, DMI 2.0, SM BIOS 2.4, ACPI 1.0b Unique Features 1. Support for @BIOS 2. Support for Q-Flash 3. Support for Dual BIOS 4. Support for Download Center 5. Support for Xpress Install 6. Support for Xpress Recovery2 7. Support for EasyTune 8. Support for Dynamic Energy Saver Advanced 9. Support for Time Repair 10. Support for Q-Share Bundle Software 1. Norton Internet Security (OEM version) Form Factor 1. ATX Form Factor; 30.5cm x 24.4cm Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.
Скачать